Amazon.com.mx:Opiniones de clientes: WALI un par de Side Estante Soporte de Montaje con inclinación y Giro de Altavoz de sujeción para Surrounding Sound

Mejor opinión positiva

Escritorio mucho más limpio!

Revisado en México el 18 de agosto de 2021

Estas bases junto con la del monitor ayuda bastante a trabajar con un espacio más amplio y limpio! El precio esta increíble para las bases. Sostienen perfectamente mis bocinas Edifier R1280DB

A 7 personas les resultó útil

Mejor opinión crítica

Todas las opiniones críticas›

Fernando Perez

BUEN PRODUCTO

Revisado en México el 27 de octubre de 2021

Todo como decia la descripción

Ordenar por

Filtrar por

Filtrado por

4 estrellasBorrar filtro

412 calificaciones totales, 93 con opiniones

Ha surgido un problema al filtrar las opiniones justo en este momento. Vuelva a intentarlo en otro momento.

Traducir todas las opiniones al Español

De otros países

Tophie

Mounting covers slide off easily

Reseñado en los Estados Unidos el 16 de julio de 2019

Compra verificada

These are great speaker mounts. I recommend these even in the face of the following [somewhat questionable] complaints:

They were very easy for me to put together, but I have a great concept of three-dimensional manipulation and am quite dexterous. There are a lot of things you have to hold in place with your fingers before being able to bolt it all together. They're heavy for their size and an odd shape, which may make assembly annoying for some.

The plastic plates which cover the mounting bracket aren't affixed to the frame in any way. Bass frequencies cause these to slide along the frame, and thus off the wall, very frequently. Even when just listening to spoken word. I'm sure some sticky tack will fix this, but I have none on hand. The second picture in this review highlights this issue.

There are holes in the frame through which one can run speaker wire. This is a great feature, but unfortunately while these holes are large enough for speaker wire, they are too small for speaker cables and power cables. I am using powered speakers, so these holes serve me no purpose.

The acorn nuts protruding from the base of the mounts lend an industrial aesthetic; which is not in my favor, but only a concern now that I am inspecting the items for this review. They're not horrendous, just make sure you don't scratch the black paint off of them.

I wish they had a higher range of motion. In the first picture for this review, they are tilted down as far as they go. Due to the size of my monitor, and wall studs being 16" on-center, this was the only place I could install them. They are aimed slightly above my head; which is not ideal for music production, but works perfectly fine.

All in all, this is a great product. Even though there are certainly better options out there, I would recommend these to anyone simply for the price and build quality.

A una persona le resultó útil

Traducir opinión al idioma Español

K. Kellogg

Very affordable wall mount that delivers in every way but could use a greater tilt adjustment angle

Reseñado en los Estados Unidos el 5 de diciembre de 2018

Compra verificada

I love how sturdy this wall mount is. It came with the proper screws of excellent quality and the directions are clear and understandable. The one little annoyance is that the speakers are designed to tilt no more than 7 degrees. Their satisfaction with this limitation has to be with product liability or something like that. The Caveat? It sits on a plate that allows you to hold the speaker by using screws into the bottom, the side and by compression from the sides with an turnbuckle that tightens as you turn it. Initially my solution was to leave the bottom rear screw out and make shims from a rubber elastic strap I used to hold my jet-ski to the trailer but it looked slightly funky, so just when I had a deadline due, I thought perhaps the way to do this was to go dig the Klipsch speaker boxes out and attach the rubber feet first and then sit those on the rear. There is but on screw on the rear bottom of the mounting plate. I thought about using a long screw to hold it just in case, but I am not keen on damaging the speaker in any way. The speaker wire can be guided into the wall or alone a seam somewhere on the outside.
This mounting bracket is very affordable and is the only one I found that was strong enough to hold onto 50 year old gypsum walls with ease and costs far less that it's competitors.

A una persona le resultó útil

Traducir opinión al idioma Español

Bob D.

Very good speaker mount.

Reseñado en los Estados Unidos el 8 de marzo de 2017

Compra verificada

Quality product, looks very nice on wall. Mount is all steel construction except for the cover plate which is plastic. Rated for up to 55 lbs and looks to be easily capable of that. Installed into wall studs with included lag screws with no problems. Use a #3 Philips head screw driver to prevent stripping of screw head and be sure to pre-drill holes. Used these to install Polk Monitor 45 speaker on wall, 16 lbs, 16h x 7w x 12d, I used the small screws to secure the speakers to the mount only because when I tilted speaker down it was a tiny bit wobbly. I'm sure that it wont fall but don't want to risk it falling on someones head. Liked them so much I purchased a second set to mount my Polk TSI100 surround speakers, they're a bit smaller, 11h x 7w x 10d, 8lbs, they were rock solid with just the clamps tilted forward. Even though they have the ability to be hung on the wall with a keyhole mount, I wanted the ability to swivel and tilt them.

I plan on eventually running the speaker cables through the wall, the only problem I foresee would be that the wall stud is directly behind where a wire would go through the mount, one star deduction. I'll probably just use wire plates next to the mounts when I take on that project.

A 2 personas les resultó útil

Traducir opinión al idioma Español

Eliot N.

Not for Sonos one sl

Reseñado en los Estados Unidos el 14 de diciembre de 2021

Compra verificada

This product work on larger speaker monitors it will not work on sonos, LG or Samsung soundbar rear speakers. I kept them because well I needed them so bad and I was able to cut the base with a grinder and modify the base with drilled holes but I had to remove the rubber base shoes in order to use the speaker screws to attach the speaker. I am satisfied with the way thy ended up with a little engineering they look nice and I am able to provide enough pivot and incline but must say it only work at 5 feet or less as the inclination is very limited at higher altitude which by the way for the best experience in soundbars with dolby atmos lower and more direct radiation is the recommended by most manufacturer. I don't have a step by step procedure so if you decide to modify a mental cutting grinder and drill are required to do the job good luck out there.

Traducir opinión al idioma Español

Austin Rodden

Flexible install for larger bookshelf speakers

Reseñado en los Estados Unidos el 7 de junio de 2019

Compra verificada

I purchased these to mount some B&W 602 S3's, The feature that stood out above others in the same category was the clamping action. The clamp has a nice piece of padding that grips very well. No need to put screws in your speakers or worry about them falling out when mounted at an angle. Installation took only a few minutes each.
The tilt feature is a plus, there is a friction disk that allows you to tilt the speakers w/o loosening the tension bolt. Each side of the clamp has a dedicated bolt that adjust the clamp so that you can set the speaker offset if needed.
You will want to purchase something other than the provided wall anchors as they are over size and not needed if your mounting a speaker under 20lbs.
I Recommend the EZ-Anchor for drywall mounting W/O a stud as its self drilling and can be easily removed.

Traducir opinión al idioma Español

bottlecap

Solid wall mount, could be easier to install

Reseñado en los Estados Unidos el 13 de septiembre de 2020

Compra verificada

Pros:
- Sturdy and easy to adjust speakers.
- Holds speaker effectively.
- Speaker wire is effectively hidden and helps hold the speaker in place by attaching to the back of the speaker.

Cons:
- Installation was interesting. In order to attach this to the wall, you don't want the plastic cover on so that the screws are accessible. In order to string the speaker wire through the back, the plastic cover needs to be on. This becomes a bit of an ordering problem. We ended up detaching the metal arm from the back-plate and then re-attaching it after the back-plate was installed.

Traducir opinión al idioma Español

dSeLeKTa

Needs to include better hardware. Also should provide more tilt to be 5 star.

Reseñado en los Estados Unidos el 8 de mayo de 2022

Compra verificada

Fairly good option with some caveats. I like you can run the wires through the arm assembly for a clean look. The drywall anchors it comes with are not useful and so you will want to use your own. They are sturdy but the beauty cap that covers the wall plate is kinda cheap and loose fitting. I am pretty satisfied for the price.

Traducir opinión al idioma Español

Lisa

Excellent price, almost perfect.

Reseñado en los Estados Unidos el 15 de noviembre de 2020

Compra verificada

These installed easily and hold my larger Pioneer SP-BS22Lr Andrew Jones bookshelf speakers really well. Speakers are 7 1/8" W x 12 9/16" H x 8 7/16" D and weigh 9lbs 2oz each. I did not use the included wood screws on my speakers and only relied on the compression fit. This holds them very well and I am not worried about the speakers falling. On the bad side the packaging is not great and there were visible scuff marks and paint wear areas on the mounts. Luckily these were on the back side. The plastic covers which slide over the screw areas very in consistency one fit very well the other I had to add some black electrical tape to provide a more snug fit. Overall I am happy with the purchase and would buy them again.

Traducir opinión al idioma Español

Terry

Works great for Bose SoundTouch 10

Reseñado en los Estados Unidos el 17 de febrero de 2019

Compra verificada

I purchased this for Bose SoundTouch 10. The fit is great. The materials are heavy duty, especially considering the price point. Deducted one star because the product comes only with concrete anchors and wood screws. I have to think the most common install is into Sheetrock, so why not include Sheetrock anchors? I wanted to install in a corner, which doesn’t work, but was able to go about 1.5” out from the corner and still be able to angle the platform. There is a opening for a cord, but it is too narrow for a two prong power cord. This doesn’t really matter since there is plenty of room for the cord to run next to the platform.

Traducir opinión al idioma Español

Amazon Customer

Good Product, did not fit my speaker correctly

Reseñado en los Estados Unidos el 25 de febrero de 2022

Compra verificada

Looking at the pic, I assumed it would fit my speakers standing upright as the speakers displayed in the ad looked identical to mine, when receiving the brackets I had to turn the speakers on their sides so the clamps would work, all is operating fine, just wished I had looked at measurements first

Traducir opinión al idioma Español

¿Alguna pregunta? Obtén respuestas rápidas de personas que han opinado.

¿Necesitas el servicio de asistencia al cliente? Haga clic aquí

‹ Mostrar todos los detalles para WALI un par de Side Estante Soporte de Montaje con inclinación y Giro...

5 estrellas		80%
4 estrellas		13%
3 estrellas		3%
2 estrellas		1%
1 estrella		3%

WALI un par de Side Estante Soporte de Montaje con inclinación y Giro...

›

Opiniones de clientes

Opiniones de clientes

WALI un par de Side Estante Soporte de Montaje con inclinación y Giro de Altavoz de sujeción para Surrounding Sound – Altavoces swm201 Grande, Color Negro

Mejor opinión positiva

Mejor opinión crítica

Filtrado por

Ha surgido un problema al filtrar las opiniones justo en este momento. Vuelva a intentarlo en otro momento.

De otros países

¿Alguna pregunta? Obtén respuestas rápidas de personas que han opinado.

WALI un par de Side Estante Soporte de Montaje con inclinación y Giro... › Opiniones de clientes

Opiniones de clientes

WALI un par de Side Estante Soporte de Montaje con inclinación y Giro de Altavoz de sujeción para Surrounding Sound – Altavoces swm201 Grande, Color Negro

Mejor opinión positiva

Mejor opinión crítica

Filtrado por

Ha surgido un problema al filtrar las opiniones justo en este momento. Vuelva a intentarlo en otro momento.

De otros países

¿Alguna pregunta? Obtén respuestas rápidas de personas que han opinado.

WALI un par de Side Estante Soporte de Montaje con inclinación y Giro...

›

Opiniones de clientes